 HomeProductsHydraulic Power UnitPOWER UNITS FOR DOUBLE-SCISSORS LIFT

Contact Supplier

Mr. xueanzhi

Leave a message

Contact Now

POWER UNITS FOR DOUBLE-SCISSORS LIFT

$260

≥1500
Piece/Pieces

Min. Order:

1500 Piece/Pieces

Contact Now

Product Description

Product Attributes
Supply Ability & Additional Information

< >

Overview

Product Attributes

Model No.: 14985

Supply Ability & Additional Information

Place of Origin: China

With a typical up and down gravity drop circuit, the Hydraulic Power Unit for the warehouse is designed for those escalators that require low noise level. The descending movement is controlled by the electromagnetic release valve, and the descending speed is regulated by the adjustable pressure compensation flow control valve. Pneumatic hydraulic valve.

Hydraulic Power Unit

Hydraulic Poppet Valve

Automobile hydraulic power unit

sfg63 sfg64

Hydraulic Power Unit

Model and specification

type型号	electric machinery电机	pump delivery t泵排量（cc / r）	Tank volume y油箱容积（L）	pressure 压力（MPa）	install 安装方式	Oil port 油口尺寸
HPU1-29GOE旧V DFOA	AC220V 2.2Kw 2850rpm 50Hz的	2.1	20	18岁	立式	G3 / 8“ （可定制OR 定制）
HPU1-29GPEIBVDGOA	AC220V 3.0Kw 2850rpm 50Hz的			25
HPU1-29HOEIBVDFOA	AC380V 2.2Kw 2850rpm 50Hz的			20
HPU1-29HPEIBVDGOA	380V 3.0Kw 2850rpm 50赫兹			25

Hydraulic Pilot Valve

Special notes

Power Unit

1. For pumps with different flow rates, pressure and motor power, please refer to the order guide.
2. If you need a manual oil drain device, please indicate it when ordering.
3. The power unit can not run continuously (1 minute on, 9 minutes off), and can work repeatedly.
4. Before installation, please make sure that the hydraulic components such as oil cylinder, oil pipe and joint are clean and free of any impurities.
5. The viscosity of hydraulic oil should be 15-68cst, and it should be clean and free of impurities. It is recommended to use HM46 hydraulic oil.
6. The hydraulic power unit is suitable for vertical installation.
7. After the first operation of the system, check whether there is enough oil in the oil tank immediately.
8. The hydraulic oil should be changed once in the first 100 hours, and then every 3000 hours after using the system.

Hydraulic Pump Unit

Product Categories : Hydraulic Power Unit

Hot Products

Email to this supplier

*Subject:
*To:

Mr. xueanzhi
*Email:
*Message:

Your message must be between 20-8000 characters